IP Multicast Route Configuration
© Copyright Lenovo 2017
The following table describes the IP Multicast (IPMC) route commands.
Note: Before you can add an IPMC route, IGMP must be turned on, IGMP
Snooping/Relay must be enabled, and the required VLANs must be added to
IGMP Snooping/Relay.
Table 266.
IP Multicast Route Configuration Commands
Command Syntax and Usage
[no] ip mroute <IPMC destination> <VLAN ID (1‐4094)>
<port alias or number> [{primary|backup|host} [<virtual router ID>]]
Adds or removes a static multicast route. The destination address, VLAN and
member port of the route must be specified.
Command mode: Global configuration
[no] ip mroute <IP address> <VLAN ID (1‐4094)> portchannel <1‐64>
[{primary|backup|host} [<virtual router ID>]]
Adds or removes a static multicast route. The destination address, VLAN, and
member Link Aggregation Group (LAG) of the route must be specified.
Command mode: Global configuration
[no] ip mroute <IP address> <VLAN ID (1‐4094)> adminkey <1‐65535>
[{primary|backup|host} [<virtual router ID>]]
Adds or removes a static multicast route. The destination address, VLAN, and
LACP admin key of the route must be specified.
Command mode: Global configuration
no ip mroute all
Removes all the static multicast routes configured.
Command mode: Global configuration
show ip mroute
Displays the current IP multicast routes.
Command mode: All
Chapter 4: Configuration Commands
517