618
G8264 Command Reference for ENOS 8.4
Table 342.
PIM Interface Configuration Options (continued)
Command Syntax and Usage
ip pim neighboraddr <IP address> {allow|deny}
Allows or denies PIM access to the specified neighbor. You can configure a list
of up to 72 neighbors that bypass the neighbor filter. Once you configure the
interface to allow a neighbor, you can configure the interface to deny the
neighbor.
Command mode: Interface IP
[no] ip pim neighborfilter
Enables or disables the PIM neighbor filter on the interface. When enabled,
this interface does not accept any PIM neighbors, unless specifically permitted
using the following command: ip pim neighboraddr <IP address>
Command mode: Interface IP
ip pim overrideinterval <0‐65535>
Configures the override interval for the router interface, in seconds.
Command mode: Interface IP
[default|no] ip pim overrideinterval
Resets the override interval for the router interface to its default value.
Command mode: Interface IP
default ip pim
Resets the PIM configuration on the interface to its default values.
Command mode: Interface IP
show ip pim neighborfilters
Displays the configured PIM neighbor filters.
Command mode: All
show ip pim interface [<1‐126>|detail|loopback <1‐5>|port
<port alias or number>]
Displays the current PIM interface parameters.
Command mode: All