IGMP Relay Configuration
580
G8264 Command Reference for ENOS 8.4
When you configure IGMP Relay, also configure the IGMP Relay multicast routers.
The following table describes the commands used to configure IGMP Relay.
Table 310.
IGMP Relay Configuration Options
Command Syntax and Usage
[no] ip igmp relay enable
Enables or disables IGMP Relay.
Command mode: Global configuration
ip igmp relay report <0‐150>
Configures the interval between unsolicited Join reports sent by the switch, in
seconds.
The default value is 10.
Command mode: Global configuration
ip igmp relay vlan <VLAN ID (1‐4094)>
Adds the VLAN or range of VLANs to the list of IGMP Relay VLANs.
Command mode: Global configuration
no ip igmp relay vlan {<VLAN ID (1‐4094)>|all}
Removes all VLANs or just the specified VLAN from the list of IGMP Relay
VLANs.
Command mode: Global configuration
show ip igmp relay
Displays the current IGMP Relay configuration.
Command mode: All