Saving The Switch Configuration; Saving A Switch Dump - Lenovo ThinkSystem NE2552E Application Manual

Saving the Switch Configuration

1. Set the FTP/TFTP/SFTP server address where the configuration file is saved:
2. Set the name of the configuration file:
3. If you are using an SFTP/FTP server, enter a username:
4. If you are using an SFTP/FTP server, enter a password:
5. Initiate the transfer. To save a running configuration file, enter 4:

Saving a Switch Dump

1. Set the FTP/TFTP/SFTP server address where the configuration will be saved:
2. Set the name of dump file:
3. If you are using an SFTP/FTP server, enter a username:
4. If you are using an SFTP/FTP server, enter a password:
5. Initiate the transfer. To save a dump file, enter 5:
496
NE2552E Application Guide for ENOS 8.4
To save the switch configuration to a FTP/TFTP/SFTP server follow the steps
below. This example shows a FTP/TFTP/SFTP server at IPv4 address 192.168.10.10,
though IPv6 is also supported.
Set agTransferServer.0 "192.168.10.10"
Set agTransferCfgFileName.0 "MyRunningConfig.cfg"
Set agTransferUserName.0 "MyName"
Set agTransferPassword.0 "MyPassword"
Set agTransferAction.0 "4"
To save a switch dump to a FTP/TFTP/SFTP server, follow the steps below. This
example shows an FTP/TFTP/SFTP server at 192.168.10.10, though IPv6 is also
supported.
Set agTransferServer.0 "192.168.10.10"
Set agTransferDumpFileName.0 "MyDumpFile.dmp"
Set agTransferUserName.0 "MyName"
Set agTransferPassword.0 "MyPassword"
Set agTransferAction.0 "5"