Vmware Operations - Lenovo RackSwitch G8264 Command Reference Manual

VMware Operations

688
G8264 Command Reference for ENOS 8.4
Use these commands to perform minor adjustments to the VMware operation. Use
these commands to perform Virtual Switch operations directly from the switch.
Note that these commands require the configuration of Virtual Center access
information (virt vmware vcspec).
Table 390. VMware Operations
Command Syntax and Usage
virt vmware export <VM profile name> <VMware host ID>
<Virtual Switch name>
Exports a VM Profile to a VMware host.
Use one of the following identifiers to specify each host:
UUID

IP address

Host name

You may enter a Virtual Switch name, or enter a new name to create a new
Virtual Switch.
Command Mode: All
virt vmware pg <Port Group name> <host ID> <VSwitch name>
<VLAN ID (0‐4094)> <shaping‐enabled> [<average‐Kbps> <burst‐KB>
<peak‐Kbps>]
Adds a Port Group to a VMware host. You are prompted for the following
information:
Port Group name

VMware host ID (Use host UUID, host IP address, or host name.)

Virtual Switch name

VLAN ID of the Port Group

Whether to enable the traffic‐shaping profile (1 or 0). If you choose 1 (yes),

you are prompted to enter the traffic shaping parameters.
Command Mode: All
no virt vmware pg <Port Group name> <host ID>
Removes a Port Group from a VMware host. Use one of the following
identifiers to specify the host:
UUID

IP address

Host name

Command Mode: All
virt vmware scan
Performs a scan of the VM Agent, and updates VM information.
Command Mode: All