Ufp Configuration - Lenovo RackSwitch G8264 Command Reference Manual

UFP Configuration

© Copyright Lenovo 2017
The following table describes the Unified Fabric Port (UFP) configuration options.
UFP allows defining up to 8 virtual ports per physical port. Each virtual port can be
set up to operate in a specific mode (access, trunk, tunnel, auto, or FCoE) and within
predefined bandwidth limits.
Note: vNIC and UFP are mutually exclusive. Only one of them can be globally
enabled at any point in time.
Table 371.
UFP Commands
Command Syntax and Usage
[no] ufp enable
Globally enables or disables UFP.
Command mode: Global configuration
[no] ufp port <port number> enable
Enables or disables UFP on the specified physical port.
Command mode: Global configuration
ufp port <port number> qos­mode {bw|ets}
Configures the Quality of Service (QoS) mode for the specified UFP port.
bw ‐ performs rate bandwidth control by dividing the port's bandwidth

across the virtual ports. A minimum and a maximum limit can be
configured for each virtual port.
Note: QoS Bandwidth mode is only applicable to up to four virtual ports
per physical port.
ets ‐ Enhanced Transmission Selection (ETS) allows you to allocate

bandwidth to different virtual ports, based on 802.1q priority.
Note: QoS ETS mode requires Converged Enhanced Ethernet (CEE) to
enabled on the switch. For details, see page
The default setting is bw.
Command mode: Global configuration
ufp port <port number> vport <1‐8>
Enters UFP Virtual Port Configuration mode.
Command mode: Global configuration
no ufp port <port number> [vport <1‐8>]
Removes UFP settings from the specified physical or virtual port.
Command mode: Global configuration
[no] enable
Enables or disables the virtual port.
Command mode: UFP Virtual Port Configuration
626.
Chapter 4: Configuration Commands
649