Management Acl Configuration; Macl Ipv4 Filtering Configuration - Lenovo RackSwitch G8264 Command Reference Manual

Management ACL Configuration

MACL IPv4 Filtering Configuration

444
G8264 Command Reference for ENOS 8.4
These commands allow you to define filtering criteria for each management ACL
(MACL).
Note: Management ACLs (MACLs) are not supported on the management port,
only on data ports. Management ACLs filter traffic received through data
interfaces only. Management interface is not monitored.
Table 216.
MACL Configuration Options
Command Syntax and Usage
access­control macl <1‐128> action {permit|deny|
|set­priority <0‐7>}
Configures a filter action for packets that match the MACL definitions. You
can choose to permit (pass), deny (drop) packets or set the 802.1p priority level
(0‐7).
Command mode: Global configuration
[no] access­control macl <1‐128> enable
Enables or disables the management ACL.
Command mode: Global configuration
[no] access­control macl <1‐128> statistics
Enables or disables the statistics collection for the MACL.
Command mode: Global configuration
show access­control macl <1‐128>
Displays the current MACL parameters.
Command mode: All
These commands allow you to define IPv4 matching criteria for an MACL.
Table 217.
IP version 4 Filtering Configuration Options
Command Syntax and Usage
access­control macl <1‐128> ipv4 destination­ip­address
<IP address> [<IP mask>]
Defines a destination IP address for the MACL. If defined, traffic with this
destination IP address will match this MACL.
Command mode: Global configuration
no access­control macl <1‐128> ipv4 destination­ip­address
Deletes the configured destination IP address for the specified MACL.
Command mode: Global configuration