Lenovo RackSwitch G8264 Command Reference Manual page 574

MLD Interface Configuration
574
G8264 Command Reference for ENOS 8.4
The following table describes the commands used to configure MLD parameters
for an interface.
Table 306.
MLD Interface Configuration Commands
Command Syntax and Usage
[no] ipv6 mld dmrtr enable
Enables or disables dynamic Mrouter learning on the interface. The default
setting is disabled.
Command mode: Interface IP
[no] ipv6 mld enable
Enables or disables the selected MLD interface.
Command mode: Interface IP
ipv6 mld llistnr <1‐32>
Configures the Last Listener query interval, in seconds.
The default value is 1 second.
Command mode: Interface IP
no ipv6 mld llistnr
Resets the Last Listener query interval to its default value of 1 second.
Command mode: Interface IP
ipv6 mld qintrval <2‐65535>
Configures the interval for MLD Query Reports, in seconds.
The default value is 125 seconds.
Command mode: Interface IP
no ipv6 mld qintrval
Resets the interval for MLD Query Reports to its default value of 125 seconds.
Command mode: Interface IP
ipv6 mld qri <1000‐65535>
Configures the interval for MLD Query Response Reports, in miliseconds.
The default value is 10,000 milliseconds.
Command mode: Interface IP
no ipv6 mld qri
Resets the interval for MLD Query Response Reports to its default value of
10,000 milliseconds.
Command mode: Interface IP