Stacking Configuration - Lenovo RackSwitch G8264 Command Reference Manual

Stacking Configuration

414
G8264 Command Reference for ENOS 8.4
A stack is a group of switches that work together as a unified system. The network
views a stack of switches as a single entity, identified by a single network IP
address. The Stacking Configuration commands are used to configure a stack and
to define the Backup interface.
The Stacking Configuration commands are available only after Stacking is enabled
and the switch is rebooted. For details, see "Stacking Boot Options" on page
Note: The following commands are available only on the master switch.
Table 188.
Stacking Configuration Options
Command Syntax and Usage
connect <attached switch number (1‐16)>
Provides console access to member switches from the master switch.
Command mode: Privileged EXEC
stack backup <configured switch number (1‐8)>
Defines the backup switch in the stack, based on its configured switch number.
Command mode: Global configuration
no stack backup
Deletes the backup switch configuration.
Command mode: Global configuration
stack bind
Automatically assings configured switch numbers to all attached switches.
Command mode: Global configuration
stack name <1‐63 characters>
Defines a name for the stack.
Command mode: Global configuration
no stack name
Removes the stack name.
Command mode: Global configuration
show stack switch­number [<configured switch number (1‐8)>]
Displays the current stacking parameters.
Command mode: All
694.