Ipsec Traffic Selector Configuration - Lenovo RackSwitch G8264 Command Reference Manual

IPsec Traffic Selector Configuration

© Copyright Lenovo 2017
Table 323.
IPsec Transform Set Options (continued)
Command Syntax and Usage
no ipsec transform <1‐10>
Deletes the transform set.
Command mode: Global configuration
show ipsec transform­set <1‐10>
Displays the current IPsec Transform Set settings.
Command mode: All
The following table describes the commands used to configure an IPsec traffic
selector.
Table 324.
IPsec Traffic Selector Options
Command Syntax and Usage
ipsec traffic­selector <1‐10> {permit|deny}
{any|icmp [<ICMPv6 type (0‐255)>]|tcp} {<IPV6 address>|any}
Sets the traffic‐selector to permit or deny the specified type of traffic.
Command mode: Global configuration
no ipsec traffic­selector <1‐10>
Resets the specified traffic selector to its default values.
Command mode: Global configuration
show ipsec traffic­selector [<1‐10>]
Displays IPsec traffic selector information.
Command mode: All
Chapter 4: Configuration Commands
593