© Copyright Lenovo 2017
Table 262.
IP Interface Configuration Options (continued)
Command Syntax and Usage
[no] ipv6 unreachables
Enables or disables sending of ICMP Unreachable messages.
The default setting is enabled.
Command mode: Interface IP
[no] ip6host
Enables or disables the IPv6 Host Mode on this interface.
The default setting is disabled for data interfaces, and enabled for the
management interface.
Command mode: Interface IP
[no] relay
Enables or disables the BOOTP relay on this interface.
The default setting is enabled.
Command mode: Interface IP
tenant services tenantid <1‐30>
Defines the tenants who use the interface to access a service network. Up to 4
services per tenant are supported.
Command mode: Interface IP
no tenant services tenantid [<1‐30>]
Removes tenants who use the interface to access a service network.
Command mode: Interface IP
tenant tenantid <1‐30>
Defines the tenant downlink network. Up to 10 subnets per tenant are
supported.
Command mode: Interface IP
no tenant tenantid [<1‐30>]
Removes all tenant or a specific tenant from the current interface.
Command mode: Interface IP
tenant uplink tenantid <1‐30> [active|stanby]
Defines the tenants who use this interface as an uplink interface. Up to 2
uplinks per tenant are supported.
Command mode: Interface IP
no tenant uplink tenantid [<1‐30>]
Removes the tenants who use the current interface as an uplink interface.
Command mode: Interface IP
Chapter 4: Configuration Commands
509