Qsfp Port Configuration - Lenovo RackSwitch G8264 Command Reference Manual

QSFP Port Configuration

© Copyright Lenovo 2017
The following table displays the QSFP Port configuration commands.
Table 401.
QSFP Port Options
Command Syntax and Usage
[no] boot qsfp­40gports <port alias or number>
Enables or disables 40GbE mode on the selected QSFP+ ports.
When enabled, each QSFP+ port is set as a single 40GbE port.
When disabled, each QSFP+ port is configured to breakout into four 10GbE
ports.
Note: You must reboot the switch for this change to take effect.
Command mode: Global configuration
show boot qsfp­port­modes
Displays the current QSFP parameters.
Command mode: All
705
Chapter 6: Boot Options