Lenovo RackSwitch G8264 Command Reference Manual page 657

© Copyright Lenovo 2017
Table 375.
OpenFlow Configuration Options (continued)
Command Syntax and Usage
openflow fdb­timeout <1‐300>
Configures a time interval in seconds for periodically clearing dynamically
learned FDB entries on edge ports.
The default value is disabled.
Command mode: Global configuration
no openflow fdb­timeout
Disables periodical clearing of dynamically learned FDB entries on edge ports.
Command mode: Global configuration
[no] openflow mgmtport <port alias or number>
Enables or disables OpenFlow management for the selected port. Use
OpenFlow management ports to communicate with an OpenFlow Controller.
In Hybrid mode, controllers can also connect to the switch using legacy ports.
Note: Supported only in OpenFlow Only mode.
The default setting is disabled.
Command mode: Global configuration
openflow mpls­priority <1‐65535>
Configures a priority value to map flows with matching priority to MPLS
entries. The default value is 65535.
Note: Supported only in OpenFlow 1.3.
Note: When you issue this command, all the existing MPLS flows are cleared
automatically.
Command mode: Global configuration
no openflow mpls­priority
Resets the priority value required for MPLS flows to the default value of
65535.
Note: Supported only in OpenFlow 1.3.
Command mode: Global configuration
openflow instance <1‐2>
Enters OpenFlow Instance command mode for the specified instance ID.
Command mode: Global configuration
no openflow instance <1‐2>
Deletes the instance and clears flow table and statistics for the specified
instance ID.
Command mode: Global configuration
Chapter 4: Configuration Commands
657