Lenovo RackSwitch G8264 Command Reference Manual page 764

764
G8264 Command Reference for ENOS 8.4
Thread LOG_NOTICE Message (continued)
SYSTEM Port <port> disabled by OAM (unidirectional|TX‐RX Loop)
SYSTEM Port <port> disabled by UDLD (unknown|unidirectional|
bidirectional|TX‐RX loop|neighbor mismatch)
SYSTEM Port <port> disabled due to reason code <reason code>
SYSTEM Power Fault {Cleared|Detected} ‐ <number>
SYSTEM Power Supply Warning Cleared
SYSTEM rebooted (<reason>)[, administrator logged in]
Reason:
 Boot watchdog reset
 console PANIC command
 console RESET KEY
 hard reset by SNMP
 hard reset by WEB‐UI
 hard reset from console
 hard reset from Telnet
 low memory
MM Cycled Power Domain

 power cycle
Reset Button was pushed

 reset by SNMP
reset by WEB‐UI

SYSTEM Received BOOTP Offer: IP: <IP address>, Mask: <netmask>,
Broadcast <IP address>, GW: <IP address>
SYSTEM Received DHCP Offer: IP: <IP address>, Mask: <netmask> Broadcast
<IP address>, GW: <IP address>
SYSTEM server with MAC address <MAC address> was {added to|removed
from} network
SYSTEM Static route gateway <IP address> is {down|up}
SYSTEM Warning: Fan Failure
SYSTEM Warning: Power Supply Disconnected or Failure
SYSTEM Watchdog threshold changed from <old value> to <new value>
seconds
SYSTEM Watchdog timer has been enabled
TEAMING error, action is undefined
TEAMING is down, but teardown is blocked
TEAMING is down, control ports are auto disabled
TEAMING is up, control ports are auto controlled
 reset from console
 reset from EM
 reset from Telnet/SSH
 scheduled reboot
 SMS‐64 found an over‐voltage
 SMS‐64 found an under‐voltage
 software ASSERT
 software PANIC
software VERIFY

 Telnet PANIC command
unknown reason

 watchdog timer