Log_Notice - Lenovo RackSwitch G8264 Command Reference Manual

LOG_NOTICE

758
G8264 Command Reference for ENOS 8.4
Thread LOG_NOTICE Message
<minutes> {minute|minutes} until scheduled reboot
ARP table is full.
Current config successfully tftpʹd <filename> from <hostname>
Current config successfully tftpʹd to <hostname>: <filename>
ECMP route configured, Gateway health check enabled
More than one trunk found for LACP adminkey <adminkey>. Static
MAC entry <index> was added only to trunk <trunk number>.
Number of COSqs has been changed since boot. Save and reset the
switch to activate the new configuration.
Port <port> mode is changed to full duplex for 1000 Mbps
operation.
scheduled switch reboot
switch reset at <time> has been canceled
switch reset scheduled at <time>
Warning: DHCP on IF <interface> will be disabled
8021X Could not create failover checkpoint record for port <port>
8021X Logoff request on port <port>
8021X Port <port> {assigned to|removed from} vlan <VLAN>
8021X RADIUS server <IP address> auth response for port <port> has an
invalid Tunnel‐Type value (<tunnel type>); should be 13 for VLAN
assignment
8021X RADIUS server <IP address> auth response for port <port> has an
invalid Tunnel‐Medium‐Type value (<tunnel type>); should be 6 for
VLAN assignment
8021X RADIUS server <IP address> auth response for port <port> is
missing one or more tunneling attributes for VLAN assignment
8021X RADIUS server <IP address> auth response has a VLAN id
(<VLAN>) of a reserved VLAN and cannot be assigned to port
<port>
8021X RADIUS server <IP address> auth response has a VLAN id
(<VLAN>) of a non‐existent or disabled VLAN, and cannot be
assigned to port <port>
8021X RADIUS server <IP address> auth response has an invalid VLAN id
(<VLAN>) and cannot be assigned to port <port>