© Copyright Lenovo 2017
The following table describes the available matching qualifiers:
Table 377.
Static Flow Matching Qualifiers in OpenFlow 1.0
Qualifier
ingress‐port
src‐mac
dst‐mac
vlan‐id
vlan‐priority
src‐ip
dst‐ip
src‐port
dst‐port
ether‐type
protocol
tos
type
all
Table 378.
Static Flow Matching Qualifiers in OpenFlow 1.3
Qualifier
in‐port
in‐portchannel
in‐phy‐port
eth‐src
eth‐dst
vlan‐vid
vlan‐pcp
ipv4‐src
ipv4‐dst
tcp‐src
tcp‐dst
Value
Port of instance
Source MAC address
Destination MAC address
VLAN identifier (0‐4095 + 65535 (untagged))
802.1p Priority Code Point (0‐7)
Source IP address
Destination IP address
L4 source port (0‐65536)
L4 destination port (0‐65535)
ʺarpʺ/ʺ0806ʺ or ʺipʺ/ʺ0800ʺ or (hex‐value <= 65535)
ʺtcpʺ or ʺudpʺ or 0‐255
IP Type of Service (0‐255)
ʺrequestʺ or ʺreplyʺ (can be set only if ether type is
ARP)
Applicable to all traffic
Value
switch input port
switch input portchannel
switch physical input port, valid only when in‐port is
specified
source MAC address and mask
destination MAC address and mask
VLAN identifier (0‐4095 + 65535 (untagged))
802.1p(0‐7)
source IPv4 address and mask
destination IPv4 address and mask
TCP source port (0‐65535)
TCP destination port (0‐65535)
Chapter 4: Configuration Commands
667