Lenovo RackSwitch G8264 Command Reference Manual page 662

662
G8264 Command Reference for ENOS 8.4
Table 375.
OpenFlow Configuration Options (continued)
Command Syntax and Usage
no max­flow­mpls­push
Sets the instance's maximum number of MPLS label push flows to the default
value of 0 (dynamic allocation).
Note: Supported only in OpenFlow 1.3.
Command mode: OpenFlow Instance
max­flow­ucast­fdb <0‐123904>
Enables or disables the maximum flow unicast FDB option, which ensures a
dedicated maximum number of FDB unicast flows available for the instance.
The total number of entries is shared between instances.
By default, max­flow­ucast­fdb is set to 0, allowing instances to
dynamically access the available FDB unicast flow slots until depletion.
Note: Setting max­flow­ucast­fdb manually limits the number of FDB
unicast flow slots available for other instances by the corresponding value.
Command mode: OpenFlow Instance
no max­flow­ucast­fdb
Sets the instance's maximum number of FDB based unicast flows to the default
value of 0 (dynamic allocation).
Command mode: OpenFlow Instance
[no] member <port alias or number>
Enables or disables port usage by the OpenFlow instance for data traffic.
Command mode: OpenFlow Instance
[no] member portchannel <1‐128>
Enables or disables static portchannel or LACP usage by the OpenFlow
instance for data traffic.
Note: Static portchannels and LACPs are supported only in OpenFlow 1.3.
Command mode: OpenFlow Instance
min­flow­timeout <1‐300>
Sets the minimum number of seconds after which a flow can be cleared from
the instance's tables.
The default value is 0, meaning controller provided values are used instead.
Command mode: OpenFlow Instance
no min­flow­timeout
Sets the number of seconds after which a flow can be cleared from the
instance's tables to the default value of 0 (controller provided values).
Command mode: OpenFlow Instance