Port Link Configuration - Lenovo RackSwitch G8264 Command Reference Manual

Port Link Configuration

© Copyright Lenovo 2017
Use these commands to configure link‐level parameters for the port/portchannel.
Table 182.
Port Link Configuration Options
Command Syntax and Usage
[no] auto
Enables or disables auto‐negotiation.
Note: Data ports are fixed at 10000 Mbps, and cannot be set to auto‐negotiate,
unless a 1 Gb SFP transceiver is used.
Command mode: Interface port/Interface portchannel
duplex {full|half|auto}
Sets the operating mode. The choices include:
Auto negotiation (default)

Half‐duplex

Full‐duplex

Note: Data ports are fixed at full duplex.
Command mode: Interface port/Interface portchannel
flowcontrol {receive|send} {on|off}
Turns flow control receiving or transmiting on or off.
Command mode: Interface port/Interface portchannel
no flowcontrol
Disables flow control on the current port.
Command mode: Interface port/Interface portchannel
show interface port <port alias or number>
Displays the specified port's parameters.
Command mode: All
Chapter 4: Configuration Commands
407