Port Configuration - Lenovo RackSwitch G8264 Command Reference Manual

Port Configuration

400
G8264 Command Reference for ENOS 8.4
Use the Port Configuration commands to configure settings for interface ports.
Table 179.
Port Configuration Options
Command Syntax and Usage
interface port <port alias or number>
Enter Interface port mode.
Command mode: Global configuration
interface portchannel {<1‐64>|<65‐128>|lacp <1‐65535>}
Enter Interface portchannel mode. These commands allow you to configure
port parameters for all port members in the selected Link Aggregation Group
(LAG).
Command mode: Global configuration
[no] openflow mgmtport <port alias or number>
Enables or disables OpenFlow management state for the ports.
Note: Supported in OpenFlow Only mode.
Command mode: Global Configuration
[no] bpdu­guard
Enables or disables BPDU guard, to avoid Spanning‐Tree loops on ports
configured as edge ports.
Command mode: Interface port/Interface portchannel
description <1‐64 characters>
Sets a description for the port. The assigned port description appears next to
the port number on some information and statistics screens.
The default is set to the port number.
Command mode: Interface port/Interface portchannel
no description
Removes the interface description.
Command mode: Interface port/Interface portchannel
dot1p <0‐7>
Configures the port's 802.1p priority level.
Command mode: Interface port/Interface portchannel
dot1x
Configures 802.1X port‐based authentication. For more command options, see
page 455.
Command mode: Interface port