VRRP Tracking Configuration
612
G8264 Command Reference for ENOS 8.4
These commands are used for setting weights for the various criteria used to
modify priority levels during the master router election process. Each time one of
the tracking criteria is met (see "VRRP Virtual Router Priority Tracking
Commands" on page
606), the priority level for the virtual router is increased by a
defined amount.
Table 337.
VRRP Tracking Configuration Options
Command Syntax and Usage
trackingpriorityincrement interfaces <0‐254>
Defines the priority increment value for active IP interfaces detected on this
switch.
The default value is 2.
Command mode: Router VRRP
trackingpriorityincrement nexthops <0‐254>
Defines the priority increment value for each next‐hop that is active or
subtracted.
The default value is 2.
Command mode: Router VRRP
trackingpriorityincrement ports <0‐254>
Defines the priority increment value for active ports on the virtual router's
VLAN.
The default value is 2.
Command mode: Router VRRP
trackingpriorityincrement virtualrouters <0‐254>
Defines the priority increment value (0 through 254) for virtual routers in
master mode detected on this switch.
The default value is 2.
Command mode: Router VRRP
show ip vrrp trackingpriorityincrement
Displays the current configuration of priority tracking increment values.
Command mode: All
Note: These priority tracking options only define increment values. These options
do not affect the VRRP master router election process until options under the
VRRP Virtual Router Priority Tracking Commands (see page
606) are enabled.