Custom Daylight Saving Time Configuration - Lenovo RackSwitch G8264CS Cli Command Reference

Custom Daylight Saving Time Configuration
© Copyright Lenovo 2017
Use these commands to configure custom Daylight Saving Time. The DST is
defined by two rules, the start rule and end rule. The rules specify the dates when
the DST starts and finishes. These dates are represented as specific calendar dates
or as relative offsets in a month (for example, ʹthe second Sunday of Septemberʹ).
Relative offset example:
2070901 = Second Sunday of September, at 1:00 a.m.
Calendar date example:
0070901 = September 7, at 1:00 a.m.
Table 166.
Custom DST Options
Command Syntax and Usage
[no] system custom­dst enable
Enables or disables the Custom Daylight Saving Time settings.
Command mode: Global configuration
system custom­dst start­rule <WDDMMhh>
Configures the start date for custom DST, as follows:
WDMMhh
W = week (0‐5, where 0 means use the calendar date)
D = day of the week (01‐07, where 01 is Monday)
MM = month (1‐12)
hh = hour (0‐23)
Note: Week 5 is always considered to be the last week of the month.
Command mode: Global configuration
system custom­dst end­rule <WDDMMhh>
Configures the end date for custom DST, as follows:
WDMMhh
W = week (0‐5, where 0 means use the calendar date)
D = day of the week (01‐07, where 01 is Monday)
MM = month (1‐12)
hh = hour (0‐23)
Note: Week 5 is always considered to be the last week of the month.
Command mode: Global configuration
show custom­dst
Displays the current Custom DST configuration.
Command mode: All
Chapter 4: Configuration Commands
355