682
G8264 Command Reference for ENOS 8.4
Table 385.
Scheduler Jobs Management Configuration Commands
Command Syntax and Usage
event counter memory ge <1‐50>
Triggers a script execution when memory usage percentage exceeds an user
defined threshold. Memory usage percentage is checked every 60 seconds.
Command mode: Scheduler Job
event syslog <event type>
Configures the syslog event which triggers the scheduled job. The following
syslog event types are allowed:
BGPSESDOWN (BGP neighbor session failed event)
BGPSESUP (BGP neighbor session established event)
DOT1XFAIL (802.1x authentication failure event)
ISLVLGDOWN (vLAG ISL down event)
ISLVLGUP (vLAG ISL up event)
LINKDOWN (port link down event)
LINKUP (port link up event)
LLDPDISCOVER (LLDP neighbor add or delete event)
Note: When a LLDP trap is detected, the scheduler automatically triggers a
job.
LOGINFAIL (switch user login fail event)
LOGINSUCC (switch user login success event)
MBURST (microburst)
Note: All ports microburst state is checked every 10 seconds. When a port goes
into bursting state, the scheduler automatically triggers a job.
MGTGWDOWN (Mgmt gateway unavailable event)
MGTGWUP (Mgmt gateway available event)
MROUTERNEW (new multicast router learned event)
STGTPCH (STG topology change event)
VRRPBKP (VRRP becoming backup event)
VRRPMRS (VRRP becoming master event)
Note: In order to trigger an event, the syslog for each corresponding event
type must be enabled.
Command mode: Scheduler Job
event time absolute <yyyy> <mm> <dd> <hh:mm:ss> [interval
[<5‐86400>|<hh:mm:ss>]]
Triggers a script execution at a specific given date. The script runs only once if
no time interval is configured.
Note: If system time zone changes, all absolute timer jobs are automatically
rescheduled.
Command mode: Scheduler Job