Ospfv3 As-External Range Configuration - Lenovo RackSwitch G8264 Command Reference Manual

OSPFv3 AS-External Range Configuration

550
G8264 Command Reference for ENOS 8.4
The following table describes the OSPFv3 AS‐External Range commands.
Table 291.
OSPFv3 AS_External Range Configuration Options
Command Syntax and Usage
summary­prefix <1‐16> address <IPv6 address> <IPv6 prefix length (1‐128)>
Configures the base IPv6 address and the subnet prefix length for the range.
Command mode: Router OSPF3
summary­prefix <1‐16> aggregation­effect {allowAll|denyAll|
|advertise|not­advertise}
Configures the aggregation effect, as follows:
allowAll: If the area ID is 0.0.0.0, aggregated Type‐5 LSAs are generated.

Aggregated Type‐7 LSAs are generated in all the attached NSSAs for the
range.
denyAll: Type‐5 and Type‐7 LSAs are not generated.

advertise: If the area ID is 0.0.0.0, aggregated Type‐5 LSAs are generated.

For other area IDs, aggregated Type‐7 LSAs are generated in the NSSA area.
not­advertise: If the area ID is 0.0.0.0, Type‐5 LSAs are not generated,

while all NSSA LSAs within the range are cleared and aggregated Type‐7
LSAs are generated for all NSSAs. For other area IDs, aggregated Type‐7
LSAs are not generated in the NSSA area.
Command mode: Router OSPF3
summary­prefix <1‐16> area <area index (0‐2)>
Configures the area index used by the switch.
Command mode: Router OSPF3
[no] summary­prefix <1‐16> translation
When enabled, the P‐bit is set in the generated Type‐7 LSA. When disabled, the
P‐bit is cleared. The default setting is disabled.
Command mode: Router OSPF3
[no] summary­prefix <1‐16> enable
Enables or disables the OSPFv3 AS‐external range.
Command mode: Router OSPF3
no summary­prefix <1‐16>
Deletes the OSPFv3 AS‐external range.
Command mode: Router OSPF3
show ipv6 ospf summary­prefix <1‐16>
Displays the current OSPFv3 AS‐external range.
Command mode: All