Replacing The Oil Filter - SELVA MARINE Wahoo 15 Service Manual

2
NOTE:
• Be sure to clean up any oil spills.
• When using an oil changer to change the
engine oil, insert the oil changer hose into
the oil dipstick hole.
4. Install the engine oil drain bolt 2, and
then tighten it to the specified torque.
Engine oil drain bolt 2:
27 N·m (2.7 kgf·m, 19.9 ft·lb)
5. Pour the specified amount of the recom-
mended engine oil into the oil filler hole.
Recommended engine oil:
4-stroke motor oil
API: SE, SF, SG, SH, SJ, or SL
SAE: 5W-30, 10W-30, or 10W-40
Engine oil quantity:
Without oil filter replacement:
1.6 L (1.69 US qt, 1.41 Imp qt)
6. Install the oil filler cap and oil dipstick,
and then start the engine and warm it up.
7. Turn the engine off, and then check the
oil level and that there is no oil leakage. If
the oil level is low, add engine oil to the
correct level.

Replacing the oil filter

1. Drain the engine oil or use an oil changer
to extract it.
2. Place a rag under the oil filter, and then
remove the oil filter using a 64 mm (2.5
in) oil filter wrench 1.
6AG3J11
S6AG3080
NOTE:
• Wait more than 5 minutes after turning the
engine off to replace the oil filter.
• Be sure to clean up any oil spills.
3. Apply a thin coat of engine oil to the O-
ring of the new oil filter.
4. Install the oil filter, and then tighten it to
the specified torque using a 64 mm (2.5
in) oil filter wrench.
E
5. Pour the specified amount of the recom-
mended engine oil into the oil filler hole.
3
Fuel system / Power unit
1
Oil filter wrench 1: 90890-01426
Oil filter:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
Recommended engine oil:
4-stroke motor oil
API: SE, SF, SG, SH, SJ, or SL
SAE: 5W-30, 10W-30, or 10W-40
Engine oil quantity:
With oil filter replacement:
1.8 L (1.90 US qt, 1.58 Imp qt)
1
2
S6AG3090
3
4
5
6
7
S6AG3100
8
9
3-4