6.2.1 BCR Failed (BCR is the Barcode Reader)
During POST (Power On Self Test) the Barcode Reader failed, is installed improperly,
or is configured improperly. If there is no Barcode Reader, set the
in the
Configuration\Advanced\Changer\Mechanics
6.2.2 BCR Misconfigured (BCR is the Barcode Reader)
During POST (Power On Self Test) the system detected that the Barcode Reader is
configured improperly.
6.2.3 Calibration Req'd
A change has been made to the RLS configuration that disabled the library pending
calibration. Re-calibration is required!
6.2.4 Not Configured
The library is not configured. Configure the library as described in the Installation
and Operation Manual (Qualstar document number 501500).
6.2.5 Carousel Failed, Carousel Jammed
The carousel mechanism failed to move successfully or is jammed. Open the Top Cov-
er (see Section 7.6) and check that all the magazines and cartridges on the carousel
are properly seated. Verify the drive belt is in place and free of slack.
6.2.6 Array Failed, Array Jammed
The Storage Array mechanism has failed to move successfully. Open the Top Cover
(see Section 7.6) and check that all the magazines and cartridges on the Storage Ar-
ray are properly seated.
6.2.7 Gripper Homing Failed
During POST (Power On Self Test), the Gripper Home Sensor did not indicate the
gripping mechanism reached its home position. This could be caused by a failed infra-
red emitter or detector, requiring replacing the Carriage Assembly. A large piece of
dust or an errant barcode label in the Handler could also cause this failure.
6.2.8 X Failed to Home
During POST (Power On Self Test) the RLS did not detect that the Handler success-
fully reach its home position at the right side of the Carriage Assembly. Check that
there are no loose magazines or cartridges in the library. Check that the Tape Drives
are properly seated and their locking levers are fastened in the up position. Check
501510 Rev. S
Troubleshooting
value to
BCR
None
menu.
6-3