CHAPTER 8
SYSTEM MAINTENANCE
5.3 MIS Fault Recovery Procedures
This paragraph describes the fault recovery procedures related to the MIS in the order shown below.
(1) MIS Restart Processing
STEP 1: By selecting MIS System Stop, cause the MIS to stop operating.
STEP 2: Turn off the power supply to the MIS. After taking for 5 ~ 6 seconds, turn on the power supply again.
STEP 3: The MIS starts up.
STEP 4: Perform operation tests of the MIS.
(2) Check on Connection Cables
Check to see if the cable is connected between the MIS and the System.
– 382 –