NEC Univerge SV8500 Programming Manual page 124

Hide thumbs Also See for Univerge SV8500:
Table of Contents

Advertisement

13. Some notices for commands data programming are described below.
See Figure "Network Configuration of ACD systems" for network configuration of ACD systems.
Command Data
AMNO (Monitor Number Data)
(Back-up UCD) Note
ACNO (Conversion Number Data)
AADT (Announcement/Dictation Data)
AOKC (OAI Key Code Data)
AKYD (Key Data for Dterm)
ASFC
(Service Feature Restriction Class Data)
ASHU (Station Hunting Group-UCD Data)
: Assign data by the corresponding commands written in DM.
N : Assign data by the corresponding commands written in NDM.
L : Assign data by the corresponding commands written in LDM when the call is not terminated from other nodes.
F : UCD for FCCS service must be used for the back-up UCD.
When a COT card is used for back-up UCD, assign the UCD pilot number for the destination of RT and
Note:
TK for COT card using ACSI command data.
The system may not be operated normally if the above-mentioned data (especially, system data in item 1) is not
programmed correctly or the required software (also, described in item 1) is not installed yet. Data to be checked in
case of the following faults are shown below.
The data marked "*" means system must be initialized after data change.
Note:
(a) ACD data can not be programmed.
- Data Programming
• ACDP in service/out of service (ASYD: SYS1, INDEX2, b0)
• IP in system 0 is used/not used (ASYD: SYS1, INDEX207, b0)
• IP in system 1 is used/not used (ASYD: SYS1, INDEX207, b1)
• Built-in ACDP is used/not used (ASYDL: SYS1, INDEX864, b0)
(b) The agent can not log on to a position.
- Software to be installed
• Software install for "AGENT ANYWHERE" (APL-NETOAIACD)
- Data Programming
• FPC number of the VNDM Center Node (ASYDN: SYS1, INDEX533)
(By using CBCV command, broadcast the VNDM data from the VNDM Center node to all the
VNDM Local node in FCCS Network.)
• "AGENT ANYWHERE" is in service/out of service (ASYDL: SYS1, INDEX864, b2)
• "MULTIPLE ACDPs in an FCCS Network" is in service/out of service (SYS1, INDEX864, b3)
Type of Networks and Nodes
– 108 –
CHAPTER 4
OFFICE DATA DESIGN
I
II
III
Node
Node
Node
Node
A
B
C
N/L
F
N/L
N
F
F
IV
Node
Node
D
E
F
N
N
F
F
N
N
N
N
F
F
F

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Univerge sv7000

Table of Contents