NEC Univerge SV8500 Programming Manual page 198

e. The cumulative amount of time spent in Work mode during the shift in hours, minutes, and seconds; for
example, WORK 2:07:25.
f. The cumulative amount of time spent in Break mode during the shift in hours, minutes, and seconds; for
example, BREAK 1:02:41.
g. Finally, the display shows VACANT.
SERVICE CONDITIONS
1. When a vacant position displays R.I.P. (Reset In Progress), it indicates that the system is unable to communicate
with the telephone instrument. If the LOGON key is pressed and the connection is established, the display will
show VACANT within five seconds. If the connection cannot be established, R.I.P. will continue to be dis-
played.
PROGRAMMING
[When ID code is used]
STEP 1: ACDSPL - Set the ID code is required to logon for each split.
LOGID = 1 (ID code is required)
STEP 2: ACDLOG - Assign the ID code to logon
LID: (9 digits at the maximum)
"0" is not recognized at the first digit.
Note:
NAME: Logon ID name (14 characters at the maximum)
NAMES: Abbreviated ID code name (5 digits at the maximum)
[When ID code is not used]
STEP 1: ACDSPL - Set the ID code is not necessary to logon for each split.
LOGID = 0 (ID code is not required)
L-19A LOGON/LOGOFF - ACD
– 182 –