NEC Univerge SV8500 Programming Manual page 376

For the detailed information about this ACDP initialization, refer to the "ACDIZ Command" in CHAPTER
Note 1:
6.
This data setting causes the ACD system to temporarily stop its operating. Thus, this data setting must be
Note 2:
performed deliberately.When using ACD FCCS service, this data setting must be performed at all nodes in
the FCCS network.
(When the "Status Monitor Facility Request (SMFR), FN=126" is used:) System initialization and Restart-
Note 3:
ing of the UAP (including MIS) must be performed with the following caution.
When two or more UAP(s) (including MIS) is used, restart each UAP in same order used in the start-up of
the UAP(s) before the operating. If you are not sure of the order used in start-up of the UAP(s) before op-
erating, perform the Power-On Initialization at first and then restart the UAP(s).
CHAPTER 7
– 360 –
SYSTEM OPERATIONS