NEC Univerge SV8500 Programming Manual page 207

Terminal Kind / Environment
Agent/Super-
visory Posi-
tion
Dterm
DtermIP/
DtermSP30*2
Terminal*6
(*1) PRT Trunk (Dp Channel Tie Line/Primary Rate (23B + D)
(*2) Available for Q version or later/Proprietary Protocol only.
(*3) MG-24PRIA/SCA-24PRIA (Proprietary Protocol only)
(*4) MG-16SIPMGA/SCA-16SIPMGA (Available for SP-3905 MG SIP (16) PROG-A 02.01.00.00 or later). Refer to IP Periph-
eral Equipment Description for the detail.
(*5) IP terminal stands for any IP terminal other than DtermIP in this table.
(*6) Terminal stands for any terminal other than Dterm in this table.
(*7) MG-VS32VA/SCA-VS32VA (Proprietary Protocol only)
4. When using Multi-Path Monitor Connection, voice is transmitted from both the terminal and the trunk. There-
fore, when collecting a call log by IP logger, it may not be collected normally while monitoring. In this case,
this function must be disabled when using an IP logger that does not support this function.
M-28A MONITORING - ACD SUPERVISOR - ACD
When Multi-Path Monitor Connection is disabled
Conference
Calling Party
Trunk
Dterm/Trunk
IP terminal
ISDN Trunk
(PRT)*1
DtermIP/
VS-32*7
DtermSP30*2
MG(PRI)*3
MG(SIP)*4
IP terminal*5
Terminal/Trunk
Standalone
Multi-path Switch
Single-path Switch
– 191 –
Peer-to-Peer
FCCS
Single-path Switch Single-path Switch
FCCS