NEC Univerge SV8500 Programming Manual page 103

STEP 3: ATRK-
STEP 4: AADT-
TYPE:
NO:
D:
CP:
MSGT:
WAIT:
RT:
TRK:
STEP 5: MBTK/MBRT-Cancel the make busy status.
STEP 6: ARRC-
For more details of DAT card, see Installation Manual.
Note:
The announcement service is provided in FCCS network, "0" is assigned in SYS1, INDEX449, b2.
Note 1:
"CP" and "WAIT" are available when SYS1, INDEX449, b2=1.
Note 2:
"MSGT" is not available when SYS1, INDEX449, b2=1. (Normally assign "0" with that data program-
Note 3:
ming)
CDN6 (TCL) = 4 (Tie Line)
CDN28 (ANS) = 0 (Access to announcement trunk is controlled by the current operation
(Timer Control))
= 1 (Answer and Release Timings are determined by DAT itself or the
external announcement equipment)
Assign Trunk data for Announcement Trunk.
Assign Announcement/Dictation Trunks.
1 = Announcement Trunk
Announcement number (1~58)
1 = Disconnect Timer is available
Announcement Connection Pattern Note 2
0 = Multi connection
1 = Single connection
Message Timer (2-120 sec.) Note 3
Assign 16 sec./32 sec./60 sec. in the case of PA-4DATA.
Waiting Timer (2-30 sec. 2 sec. increments) Note 2
RT No.
TRK No.
Make the tandem connection between the announcement route and ACD route allow
CHAPTER 4
– 87 –
OFFICE DATA DESIGN