NEC Univerge SV8500 Programming Manual page 69

• Dterm Series E/Dterm 75 (For Desktop Terminal FLEX Keys)
KYN FKY
1 43 Log On/Off (LOG ON/OFF)
2 40 Tally (TALLY)
3 13 Three-Way Calling (CONF)
4 59 Break Mode (BREAK)
5 18 Transfer (TRF)
6 34 Release (RELEASE)
7 20 Non-Exclusive/Exclusive Hold (HOLD)
8 37 After Call Work (WORK)
• DT700 Series/DT300 Series and Dterm Series i (For Desktop Terminal FLEX Keys)
KYN FKY
1 59 Break Mode (Break)
2 40 Tally (Tally)
3 13 Three-Way Calling (Conf)
4 43 Log On/Off (Logon)
5 18 Transfer (Transfer)
6 34 Release (Release)
7 20 Non-Exclusive/Exclusive Hold (Hold)
8 37 After Call Work (Work)
9 147 Message (Message)
10 15 Speed Calling - System (Directory)
11 51 Microphone (Mic)
• When you need to rearrange the Feature key, you may change the data after "LOG OFF".
Note:
• When you change the Feature key without "LOG OFF", ACDP initialization is necessary.
• When "MON/BARGE", "EMER", "LINE", "CONF" key is used, CFT trunk data should be
programmed in ATRK.
• When using non-IP terminal such as Dterm Series E, initialize (MB key: OFF
circuit card which accommodates Agent/Supervisory positions after the completion of AKYD data
assignment.
• In case of the use of DtermSP30, it is required to assign the same Feature key as Dterm Series E/
Dterm75.
FUNCTION
FUNCTION
– 53 –
CHAPTER 4 OFFICE DATA DESIGN
→ →
ON OFF) the ELC