Windows System Recovery; Recovery Of Windows Server 2012 R2 And Windows Server 2012 - NEC Express5800/R120g-1E Maintenance Manual
Express server
Hide thumbs
Also See for Express5800/R120g-1E:
- System configuration manual (37 pages) ,
- User manual (140 pages)
Table of Contents
Advertisement
Chapter 1 Maintenance
6.
Windows System Recovery
Recover the Windows system by using the following instructions if the system does not work normally.
6.1
Recovery of Windows Server 2012 R2 and Windows Server 2012
If the Windows does not start normally, you can recover it using the feature of the Windows installation disc.
To run this feature, start the installation disc, and then choose Repair your computer in Windows Setup
wizard.
We recommend that this option is performed by the system administrator.
If the RAID controller driver is required, take the following steps:
1.
Turn on the power to the display and this server in that order or restart.
2.
When "Press <F2> Setup, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network" appears
on the lower left of the POST screen, press the <F3> key.
3.
Start the OS from the OS installation media.
The message "Press any key to boot from CD or DVD..." appears on the upper part of the screen.
To boot from the media, press the <Enter> key.
While boot-up proceeds, the message "Loading files..." appears.
4.
Choose Repair your computer in Windows Setup wizard.
5.
Click Troubleshoot.
6.
Click Advanced options.
7.
Click Command Prompt.
8.
Execute the following command to load the driver:
Specify the drive whose volume label is INTER-FLASH.
For on-board RAID controller (LSI Embedded MegaRAID):
Windows Server 2012 R2:
drvload <drive-letter>:\014\win\winnt\drivers\01_storage\1_al_07\megasr1.inf
Windows Server 2012：
drvload <drive-letter>:\014\win\winnt\drivers\01_storage\1_al_06\megasr1.inf
9.
Exit the command prompt.
The driver installation is completed.
Note
• After recovering the system, be sure to install each driver and Starter Pack.
See "Installation Guide (Windows)" to install Starter Pack and device drivers.
• If the Windows system cannot find hard disk drives, you cannot recover the
Windows system.
Tips
The volume label for each drive can be checked from the display result of the dir
command.
Example: dir C:\
Express5800/R120g-1E Maintenance Guide
6. Windows System Recovery
43
Advertisement
Table of Contents
