Ethernet Phy Status Leds; Dual Usb-To-Uart Bridge - Xilinx VCU110 User Manual

Ethernet PHY Status LEDs

[Figure 1-2, callout 19]
The Ethernet PHY status LEDs are integrated into the metal frame of the P3 RJ-45 connector.
These LEDs are visible on the left edge of the VCU110 board when it is installed into a PCIe
slot in a PC chassis. The two PHY status LEDs are integrated within the frame of the RJ45
Ethernet jack, as shown in
X-Ref Target - Figure 1-15
Details about the Tri-Mode Ethernet MAC core are provided in LogiCORE IP Tri-Mode
Ethernet MAC Product Guide for Vivado Design Suite (PG051)
The product brief for the Marvell 88E1111 Alaska Gigabit Ethernet Transceiver can be found
at the Marvell website
Contact information is at the Marvell website

Dual USB-to-UART Bridge

[Figure 1-2, callout 20]
The VCU110 evaluation board contains a Silicon Labs CP2105GM dual USB-to-UART bridge
device (U34) which allows a connection to a host computer with a USB port. The USB cable
is supplied in the VCU110 Evaluation Kit (standard type-A end to host computer, type
micro-B end to VCU110 evaluation board connector J4). The CP2105GM is powered by the
USB 5V provided by the host PC when the USB cable is plugged into the USB port on the
VCU110 evaluation board.
VCU110 Evaluation Board
UG1073 (v1.2) March 26, 2016
Figure 1-15.
Figure 1-15: Ethernet PHY Status LEDs
[Ref 30]. The data sheet can be obtained under NDA with Marvell.
www.xilinx.com
Chapter 1: VCU110 Evaluation Board Features
[Ref 9].
[Ref 30].
84
Send Feedback