Appendix A: Default Switch And Jumper Settings; Switches - Xilinx VCU110 User Manual

Default Switch and Jumper Settings
The default switch and jumper settings for the VCU110 evaluation board are provided in
this appendix.

Switches

Default switch settings are listed in
Table A-1: Default Switch Settings
Switch Function
SW1 SPST slide switch
SW12 4-pole GPIO DIP switch
5-pole configuration
SW15
DIP switch
3-pole configuration
SW16
DIP switch
Notes:
1. DIP switches are active high (connected net is pulled high when DIP switch is closed).
VCU110 Evaluation Board
UG1073 (v1.2) March 26, 2016
Table
Default
Board shipped with power switch
Off
(1)
0000
00000
(1)
POS 1-3 FPGA U1 mode M[2:0]
101
(1)
www.xilinx.com
A-1.
Comments
off
POS 1-4 GPIO active-High
POS 1-5 Zynq AP SoC
system controller U111
Appendix A
Figure 1-2 Schematic
Callout 0381556 Page
30 71
26 64
28 51
35 3
129
Send Feedback