System board and components
16.3.1.3 Concluding steps
Ê If applicable, install the riser module 1, see section
on page
71.
"Installing the air duct" on page 89
Ê
"Reassembling" on page 63
Ê
"Connecting the power cord" on page 67
Ê
"Switching on the server" on page 70
Ê
"Resuming BitLocker functionality" on page 112
Ê
Ê Enable TPM in the system board BIOS. Proceed as follows:
Ê Switch on or restart your server.
Ê As soon as the startup screen appears, enter the BIOS setup menu.
Ê Select the Advanced menu.
Ê Select the Trusted Computing submenu.
Ê Set the TPM Support and TPM State settings to Enabled.
Ê Under Pending TPM operation, select the desired TPM operation
mode.
Ê Save your changes and exit the BIOS.
I
For detailed information on how to access the BIOS and modify
settings, see the corresponding BIOS Setup Utility reference manual.
506
Upgrade and Maintenance Manual
"Handling riser modules"
RX2540 M4