9.11.5.2 Removing the FBU with the holder
Figure 218: Removing the FBU
Ê Carefully disconnect the cable end on the FBU from the FBU cable (1).
Ê Lift up the green locking handle on the FBU holder (2) while sliding the FBU
holder in the direction of the arrow as far as it will go (3).
I
After that, the hooks on the air duct will rest in the wide ends of the
keyhole slots on the holder.
Ê Lift the FBU holder from the riser card holder.
9.11.5.3 Disconnecting the FBU cable from the FBU
Ê Disconnect the FBU cable from the FBU, see section
FBU cable from the FBU" on page
RX2540 M4
321.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Disconnecting the
323