Installing The New Expansion Card; Connecting Cables To The Expansion Card; Connecting A Fbu To The Expansion Card; Concluding Steps - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

Expansion cards and backup units
9.9.5.3

Installing the new expansion card

Ê Install the new expansion card, see section
a riser module" on page
Ê If applicable, install the riser module 1, see section
module 1 (HL)" on page
Ê If applicable, install the riser module 2, see section
module 2 (HL)" on page
9.9.5.4

Connecting cables to the expansion card

Ê If applicable, connect internal cables to the expansion card.
I
For the cable plan, see chapter
9.9.5.5

Connecting a FBU to the expansion card

Ê If applicable, connect an FBU cable to the expansion card, see section
"Installing the new TFM" on page
9.9.5.6

Concluding steps

"Reassembling" on page 63
Ê
Ê Connect all external cables to the replaced expansion card.
"Connecting the power cord" on page 67
Ê
"Switching on the server" on page 70
Ê
"Enabling replaced components in the BIOS" on page 108
Ê
Ê Inform the customer about changed WWN, MAC, and SAS addresses, see
section "Looking for MAC/WWN/GUID and SAS addresses" on page
"Updating expansion card firmware" on page
Ê
"Resuming BitLocker functionality" on page 112
Ê
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I
Configuration of network settings should be performed by the
customer. For more information, see section
settings recovery" on page
288
281.
75.
79.
311.
287.
Upgrade and Maintenance Manual
"Installing an expansion card in
"Installing the riser
"Installing the riser
"Appendix B" on page
100.
"Note on network
573.
115.
RX2540 M4