Concluding Steps - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

Hard disk drives (HDD) and solid state drives (SSD)
Figure 83: Connecting the SAS expander board to the RAID controller
Ê Connect the two SAS cables to the SAS expander board:
1 from connector "MLC1" on the SAS controller to the connector "X1"
2 from connector "MLC2" on the SAS controller to the connector "X2"
Ê If applicable, connect the OOB cable to the backplane (3).
I
For the cable plan, see chapter

7.3.10.6 Concluding steps

"Installing the fan holder" on page 234
Ê
"Reassembling" on page 63
Ê
Ê Insert all HDD/SSD modules, see section
on page 148.
I
Ensure that you install the HDD/SSD module in the bay it was located
before the HDD backplane replacement.
"Connecting the power cord" on page 67
Ê
"Switching on the server" on page 70
Ê
"Resuming BitLocker functionality" on page 112
Ê
170
"Appendix B" on page
Upgrade and Maintenance Manual
573.
"Installing 3.5-inch HDD modules"
MLC 1
MLC 2
RX2540 M4