Replacing The 12X 3.5-Inch Hdd Backplane; Preliminary Steps - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

Hard disk drives (HDD) and solid state drives (SSD)

7.3.10 Replacing the 12x 3.5-inch HDD backplane

Field Replaceable Unit
(FRU)
Tools: Phillips PZ2 / (+) No. 2 screw driver / hexagon screw driver 5 mm

7.3.10.1 Preliminary steps

"Locating the defective server" on page 53
Ê
"Shutting down the server" on page 55
Ê
"Disconnecting the power cord" on page 56
Ê
"Getting access to the component" on page 58
Ê
Ê Release all HDD modules and pull them out a few centimeters, see section
"Removing 3.5-inch HDD modules" on page
I
The HDD modules need not to be removed. But if you want to remove
them nevertheless, check if all HDD/SSD modules are uniquely
identified so that you can reinsert them into their original bays.
Ê Release all dummy modules and pull them out a few centimeters, see
section "Removing a 3.5-inch dummy module" on page
"Removing the fan holder" on page 233
Ê
164 Upgrade and Maintenance Manual
Hardware: 15 minutes
151.
148.
RX2540 M4