Replacing A Riser Card; Preliminary Steps; Removing The Riser Card - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

Ê If applicable, restore LAN teaming configurations, see section
replacing/upgrading LAN controllers" on page
9.9.6

Replacing a riser card

Upgrade and Repair Unit
(URU)
Tools: Phillips PZ2 / (+) No. 2 screw driver / hexagon screw driver 5 mm
9.9.6.1

Preliminary steps

"Suspending BitLocker functionality" on page 91
Ê
"Locating the defective server" on page 53
Ê
"Shutting down the server" on page 55
Ê
"Disconnecting the power cord" on page 56
Ê
Ê Remove all external cables from the expansion card to be replaced.
"Getting access to the component" on page 58
Ê
Ê If applicable, disconnect internal cables to the expansion card.
Ê Locate the defective riser card using the onboard Local Diagnostic LEDs,
see section "Onboard indicators and controls" on page
9.9.6.2

Removing the riser card

Ê If applicable, remove the riser module 1, see section
module 1 (HL)" on page
Ê If applicable, remove the riser module 2, see section
module 2 (HL)" on page
Ê Remove the expansion card, see section
from a riser module" on page
Ê Remove the riser card, see section
RX2540 M4
74.
78.
283.
"Removing the riser card" on page
Upgrade and Maintenance Manual
Expansion cards and backup units
119.
Hardware: 5 minutes
Software: 5 minutes
"Removing the riser
"Removing the riser
"Removing an expansion card
"After
551.
72.
289