Replacing The Heat Sink (Fl) - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

Expansion cards and backup units

9.10.3.4 Replacing the heat sink (FL)

Ê Replace the standard CPU heat sink with the CPU heat sink for GPGPU
card, see section
9.10.3.5 Removing the rear air grid riser module 2
Ê Remove the rear air grid, see section
module 2" on page
9.10.3.6 Removing the slot cover riser module 2
Ê Remove the slot cover, see section
module 2" on page
9.10.3.7 Installing the riser module 2 (FL)
Ê Install the riser module 2, see section
page 86.
Cabling GPGPU M60/P100/P40/V100
Figure 198: Connecting the power cable
Ê Connect the connector "P2" of the power cable C20 to the GPGPU
M60/P100/P40/V100 (see circle).
300
"Replacing a CPU or heat sink" on page
279.
272.
Upgrade and Maintenance Manual
"Removing the rear air grid riser
"Removing the slot cover for the riser
"Installing the riser module 2 (FL)" on
355.
RX2540 M4