Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual page 530

System board and components
Ê Lift up the green locking handle on the holder (see circle) and push the
holder in the direction of the arrow as it will go (1).
Ê Remove the holder from the air duct (2).
Ê Remove the air duct, see section
Ê Disconnect both cables (C46, C47) from the system board (see figure
on page 526, 1 and 2).
Removing the Dual microSD 64GB Enterprise from the riser card holder
Figure 398: Removing the Dual microSD 64GB Enterprise from the riser card holder
Ê Remove the air duct, see section
Ê Lift up the green locking handle on the holder (see circle) and push the
holder in the direction of the arrow as it will go (1).
Ê Remove the holder from the riser card holder (2).
Ê Remove the riser module 2, see section
on page 85.
Ê Disconnect both cables (C46, C47) from the system board (see figure
on page 526, 1 and 2).
Ê Install the riser module 2, see section
page 86.
530
"Removing the air duct" on page
"Removing the air duct" on page
Upgrade and Maintenance Manual
"Removing the riser module 2 (FL)"
"Installing the riser module 2 (FL)" on
88.
392
88.
392
RX2540 M4