Install The Heat Sink, See "Installing The Heat Sink" On Page; Concluding Steps - Fujitsu PRIMERGY RX1330 M5 Upgrade And Maintenance Manual

▶ Remove the protective plastic cover from the CPU socket of the new system
board and fit it onto the socket of the defective system board which will be
sent back to spares.
Returned system boards without this cover probably have to be
scrapped.
▶ Remove the TPM, see
Installing the new system board
▶ Confirm that the CPU model number printed on the top of the CPU fits with
the requirements.
▶ Install the CPU on the new system board, see
page 235.
▶ Check the settings on the new system board, see
page 360.
▶ Install the heat sink, see
▶ Insert the system board by holding it at a slight angle. Slide the connectors
into the I/O panel.
▶ Lower the system board carefully into the chassis.
▶ Adjust the system board. If necessary adjust the position of the system
board with a gentle twisting motion (orange circles in
centering bolts).
▶ Fasten the system board with eight screws, see
▶ Connect all cables to the system board.
For the cable plans, see

Concluding steps

▶ If applicable, install the TPM, see
▶ If applicable, install the Dual microSD 64GB Enterprise, see
Dual microSD 64GB Enterprise" on page
▶ If applicable, install all M.2 SSDs, see
RX1330 M5
"Removing the TPM" on page
"Installing the heat sink" on page
"Appendix B" on page
"Installing the TPM" on page
"Installing the M.2 SSD" on page
Upgrade and Maintenance Manual
System board and components
301.
"Installing the CPU" on
"Onboard settings" on
240.
Figure 260
Figure 260.
363.
320.
show the
296.
"Installing the
313.
333