Hard disk drives (HDD) and solid state drives (SSD)
7.3.7.1
Preliminary steps
"Locating the defective server" on page 53
Ê
"Locating the defective component" on page
Ê
7.3.7.2
Removing the defective 3.5-inch HDD module
Ê Remove the HDD module, see section
on page
152.
Ê If applicable, remove the HDD from the installation frame, see section
"Handling HDDs or SSDs without installation frame" on page
7.3.7.3
Installing the new 3.5-inch HDD module
Ê If applicable, install the HDD in the installation frame, see section
HDDs or SSDs without installation frame" on page
Ê Install the HDD module, see section
page
148.
7.3.7.4
Concluding steps
Ê If the HDD/SSD is configured using a RAID controller with a RAID level
higher than "0", the rebuild will start automatically, see section
a RAID array rebuild" on page
7.3.8
Replacing the 3.5-inch HDD backplanes
Field Replaceable Unit
(FRU)
Tools: Phillips PZ2 / (+) No. 2 screw driver / hexagon screw driver 5 mm
7.3.8.1
Preliminary steps
"Locating the defective server" on page 53
Ê
"Shutting down the server" on page 55
Ê
"Disconnecting the power cord" on page 56
Ê
154
113.
Upgrade and Maintenance Manual
54.
"Removing a 3.5-inch HDD module"
139.
"Installing 3.5-inch HDD modules" on
Hardware: 10 minutes
139.
"Handling
"Performing
RX2540 M4