Figure 64: Connecting the power cables
Ê Connect the power cables to the system board:
1
PSU power cable to connector "PWR MAIN".
2
Power signal cable to connector "PC98".
I
For the cable plans, see chapter
Ê Run the power cables through the cable clamps as shown.
6.2.1.4
Concluding steps
Ê Install the system fan module, see section
on page
83.
"Reassembling" on page 67
Ê
"Connecting the power cord" on page 78
Ê
"Switching on the server" on page 80
Ê
TX1330 M4
Upgrade and Maintenance Manual
Power supply unit (PSU)
"Appendix B" on page
"Installing the system fan module"
477.
135