Removing The Expansion Card; Installing The Slot Cover In The Riser Card Holder; Concluding Steps; Replacing Expansion Cards In Riser Modules - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

Expansion cards and backup units
"Disconnecting the power cord" on page 56
Ê
"Getting access to the component" on page 58
Ê
Ê If applicable, disconnect internal cables from the expansion cards.
Ê If applicable, "Removing an SFP+ transceiver module" on page
Ê Remove the riser module 2, see section
on page 78.
9.9.4.2

Removing the expansion card

Ê Remove the expansion card, see section
from a riser module" on page
9.9.4.3

Installing the slot cover in the riser card holder

Ê Install the slot cover in the riser card holder, see section
cover" on page
V
CAUTION!
Always replace slot covers into unused PCI slot openings to comply
with applicable EMC regulations and satisfy cooling requirements.
9.9.4.4

Concluding steps

Ê Install the riser module 2, see section
page 79.
"Reassembling" on page 63
Ê
"Connecting the power cord" on page 67
Ê
"Switching on the server" on page 70
Ê
"Resuming BitLocker functionality" on page 112
Ê
9.9.5

Replacing expansion cards in riser modules

Upgrade and Repair Unit
(URU)
286
283.
268.
Upgrade and Maintenance Manual
"Removing the riser module 2 (HL)"
"Removing an expansion card
"Installing the riser module 2 (HL)" on
Hardware: 10 minutes
Software: 5 minutes
244.
"Installing the slot
RX2540 M4