Removing A Gpgpu Card In Riser Module 2 - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

9.10.4 Removing a GPGPU card in riser module 2

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver / hexagon screw driver 5 mm
9.10.4.1 Preliminary steps
Ê If applicable, "Locating the defective server" on page 53
"Suspending BitLocker functionality" on page 91
Ê
"Shutting down the server" on page 55
Ê
Ê If applicable, remove all external cables from the expansion card to be
removed.
I
If there is a cable installed to an expansion card in the upper slot, see
section
11" on page
"Disconnecting the power cord" on page 56
Ê
"Getting access to the component" on page 58
Ê
Ê If applicable, disconnect internal cables from the GPGPU card.
9.10.4.2 Removing the air duct
Ê Remove the air duct, see section
9.10.4.3 Removing the FBU
Ê If applicable, remove the FBU, see section
page 297.
9.10.4.4 Removing the riser module 2
Ê Remove the riser module 2, see section
on page 85.
RX2540 M4
"Note for installation with expansion cards in slot 5 and slot
71.
Upgrade and Maintenance Manual
Expansion cards and backup units
Hardware: 5 minutes
Software: 5 minutes
"Removing the air duct" on page
"Removing the FBU" on
"Removing the riser module 2 (FL)"
88.
303