Installing The Second/Third Sas Backplane - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

Hard disk drives (HDD) and solid state drives (SSD)

7.4.10.5 Installing the second/third SAS backplane

Ê If applicable, remove the SAS expander board holder, see section
"Removing the SAS expander board holder" on page
Ê Install the second/third backplane, see section
backplane" on page
Ê If applicable, connect the power cable to system board connector "PWR2"
(backplane 2).
Ê If applicable, connect the power cable to system board connector
"PWR 12V 3" (backplane 3).
Ê If applicable, connect the two SAS cables to the SAS controller 2 connectors
"MLC1" and "MLC2".
Ê Connect the cables to the second/third backplane, see section
SAS expander board" on page 196
on page 197.
Ê If applicable, install the SAS expander board, see section
SAS expander board" on page
Ê If applicable, install the SAS expander board holder, see section
"Connecting the SAS expander board" on page
I
For the cable plan, see chapter
7.4.10.6 Installing additional HDD/SSD modules
Ê Insert additional HDD/SSD modules, see section
HDD/SSD module" on page
7.4.10.7 Concluding steps
"Installing the fan holder" on page 234
Ê
"Reassembling" on page 63
Ê
"Installing 2.5-inch HDD/SSD modules" on page 182
Ê
"Connecting the power cord" on page 67
Ê
"Switching on the server" on page 70
Ê
"Resuming BitLocker functionality" on page 112
Ê
200
191.
or
202.
"Appendix B" on page
183.
Upgrade and Maintenance Manual
201.
"Installing the HDD
"Cabling with SAS expander board"
204.
"Installing a 2.5-inch
"Cabling with
"Installing the new
573.
RX2540 M4