Cabling with RAID controller
Figure 108: Connecting cables with RAID controller
Ê Connect the two SAS/SATA cables to the RAID controller 1:
1
To the connector "MLC1"
2
To the connector "MLC2"
7.4.9.7
Connecting the SAS cables (two 2.5-inch HDD backplanes)
Cabling without SAS expander board
Ê Connect the cables to the HDD backplanes, see section
HDD backplane" on page
Ê Connect the SAS cables of the first HDD backplane, see section
"Connecting the SAS cables (one 2.5-inch HDD backplane)" on page
RX2540 M4
Hard disk drives (HDD) and solid state drives (SSD)
192.
Upgrade and Maintenance Manual
MLC 1
MLC 2
Controller 1
"Connecting the
193.
195